HP Virtual Connect 1.10Gb-F Ethernet Module for c-Class BladeSystem User Manual
Page 52
Configuring the Virtual Connect domain using the CLI 52
alternate Virtual Connect Ethernet module. This feature can be useful when troubleshooting the Virtual
Connect manager. The network and FC processing of the Virtual Connect subsystem is not disturbed
during the restart or failover of the Virtual Connect Manager.
If the command line option
-failover
is included in the
reset vcm
command and a Virtual Connect
Ethernet module is available in the alternate I/O bay (I/O Bays 1 and 2 can host the Virtual Connect
Manager), the command line displays the message:
SUCCESS: The Virtual Connect Manager is being reset. Please wait...
The user is logged out of the session after approximately 1 minute. An attempted login to the same Virtual
Connect Ethernet Module is rejected with the message:
Virtual Connect Manager not found at this IP address.
If the user attempts to login to the alternate I/O bay, they might receive the error message during the
attempted login:
Unable to communicate with the Virtual Connect Manager. Please retry
again later.
The login should succeed after the Virtual Connect Manager has restarted on this alternate Virtual
Connect Ethernet module. Allow up to 5 minutes, depending on the enclosure configuration.
If the command line option
-failover
is not included in the
reset vcm
command or a Virtual Connect
Ethernet module is not available in the alternate I/O bay, the command line displays the message:
SUCCESS: The Virtual Connect Manager is being reset. Please wait...
The user is logged out of the session after approximately 1 minute. If the user attempts to re-login they
might receive the error message during the attempted login:
Unable to communicate with the Virtual Connect Manager. Please retry
again later.
The login should succeed after the Virtual Connect Manager has restarted. Allow up to 5 minutes,
depending on the enclosure configuration.