HP ProLiant BL495c G5 Server-Blade - Manual (Page 14)

Setup
Overview
Installation of a server blade requires the following steps:
1. Install and configure an HP BladeSystem c-Class enclosure.
2. Install any server blade options.
3. Install interconnect modules in the enclosure.
4. Connect the interconnect modules to the network.
5. Install a server blade.
6. Complete the server blade configuration.
Installing an HP BladeSystem c-Class enclosure
Before performing any server blade-specific procedures, install an HP BladeSystem c-Class enclosure.
The most current documentation for server blades and other HP BladeSystem components is available at
the HP website (
http://www.hp.com/go/bladesystem/documentation ).
Documentation is also available in the following locations:
• Documentation CD that ships with the enclosure
• HP Business Support Center website ( http://www.hp.com/support )
• HP Technical Documentation website ( http://docs.hp.com )
Installing server blade options
Before installing and initializing the server blade, install any server blade options, such as an additional
processor, hard drive, or mezzanine card. For server blade options installation information, see the HP
ProLiant BL495c Generation 5 Server Blade User Guide on the HP website
( http://www.hp.com/go/bladesystem/documentation ).
Installing interconnect modules
For specific steps to install interconnect modules, see the documentation that ships with the interconnect
module.
Setup 14