Setting proxy file service – HP StorageWorks Enterprise File Services WAN Accelerator User Manual
Page 79
HP S
TORAGE
W
ORKS
EFS WAN A
CCELERATOR
M
ANAGEMENT
C
ONSOLE
U
SER
G
UIDE
79
2 -
C
ON
FIG
URING
TH
E
HP
EF
S
WA
N
A
C
C
EL
ER
ATO
R
6. Select either, gre or l2 from the Encapsulation Scheme drop-down list to redirect
packets using Generic Routing Encapsulation (gre) or Layer-2 (l2) redirection.
The either value uses Layer-2 first, then gre.
7. Click Update Settings to apply your new settings to the running configuration.
8. Under Flags, click Source IP Hash, Source Port Hash, Destination IP Hash, or
Destination Port Hash to define the fields the router hashes on and if certain ports
should be redirected.
9. Click Update Flags to apply your new settings to the running configuration.
10. Under Ports, click Ports Disabled, Use Source Ports or Use Destination Ports.
If a source or destination is specified, the router redirects only that TCP traffic with
the same source or destination ports specified in the Ports list.
11. If you set a source or destination port, type the port number in the Add Port text
box and click Add Port. You can add 7 ports.
NOTE: For detailed information about hash table settings for WCCP, see the Cisco
documentation Web site at http://www.cisco.com/univercd/home/home.htm.
12. Under Routers, type the IP address for the router in the Add Router IP text box
and click Add Router to add additional routers to the service group.
13. Click Save to write your settings to memory or click Reset to return the settings to
their previous values.
TIP: To remove ports, click the check box next to the port name and click Remove Selected
Ports. This action applies the settings to the running configuration. Click Save to write your
settings to memory or click Reset to return the settings to their previous values.
TIP: To remove routers, click the check box next to the router IP address and click Remove
Selected Router. This action applies the settings to the running configuration. Click Save to
write your settings to memory or click Reset to return the settings to their previous values.
Setting Proxy File Service
The following section describes how to set the Proxy File Service (PFS) for the HP
EFS WAN Accelerator. It has the following sections: