HP Designjet 510 Printer series - Manual (Page 75)

Advance calibration
It is important that the paper loaded for this calibration is exactly that used for normal printing, both in quality (for
example, glossy paper) and in width (for example, A0 or 36 in). Either roll or sheet paper can be used.
The routine prints a pattern and then cuts the roll (the cutter must be set to On—see
Controlling the cutter ) or
ejects the sheet; it requires paper that is at least 65 cm/25.5 in long and at least 50 cm/19.7 in wide. You must
then reload that piece of paper as a sheet, so that the printer can accurately measure the pattern, and make
whatever adjustments are appropriate to the amount it advances between printing swaths of data. (See
Loading
sheet paper )
The pattern printed is solely for the use of the printer; you are not expected to relate any of its characteristics to the
quality of your images.
1. From the main front-panel menu, with the correct paper loaded, select the Paper menu ( ) and press Enter.
2. Select Advance calibration and press Enter.
3. Select Create pattern and press Enter.
The printer prints its calibration pattern (as represented here) and
cuts or ejects the paper.
4. Load the sheet printed side up with the dotted line at the top (that is,
rotated 90º).
5. Now select Measure pattern and press Enter.
The printer reads the calibration pattern and makes the appropriate
internal adjustments.
These Advance calibration values are used whenever you print on the
same type of paper until you have used the Advance calibration twice
more with different types of paper.
Di
rec
tion of p
ape
r whi
le
printi
ng (c
reating p
attern)
Direction of paper when
loading (measuring pattern)