HP Designjet 510 Printer series - Manual (Page 98)

Image is incomplete
• Output contains only a partial print
• Image is clipped
• Long-axis print is clipped
Output contains only a partial print
•
Did you press Cancel or Form Feed and Cut before all the data was received by the printer?
If so, you have ended the data transmission and will have to print the page again (you normally don’t need to
press Form Feed and Cut to unload the print).
• The I/O Setup > I/O Timeout setting may be too short. From the front-panel menu you can increase the
I/O Timeout setting to a longer period and then send the print again.
• The file may be too large for the printer’s memory.
Select Send Job as a Bitmap in the driver’s Troubleshooting menu (Services tab). This may slow down print
speed.
Alternatively, you can install extra memory on the HP-GL/2 Accessory Card in your printer, see
Memory .
• There may be a communications problem between your computer and the printer.
Check your interface cable.
• Check to make sure that your software settings are correct for your current page size (for example, long-axis
prints).