HP Remote Insight Lights-Out Edition II Board - Manual (Page 14)

Installing the RILOE II 14
Installing a Virtual Power Button cable (4-pin)
To enable the Virtual Power Button feature of the RILOE II on servers that use a four-pin connector on the
server system board, install the Virtual Power Button cable (4-pin) (PN 160011-001):
1. Power down the server and disconnect all power cords to remove power from the server.
2. Connect the four-pin connector on the cable to the Virtual Power Button cable connector, located on
the rear of the RILOE II.
3. Connect the four-pin connector on the other end of the cable into the four-pin connector on the server
system board.
IMPORTANT: Be sure that you do not connect the Virtual Power Button cable to the speaker connection on
the server system board.
NOTE: For detailed instructions on the location of the connector on the server system board, refer to the
documentation provided with the server.
4. Refer to the server documentation to reassemble the server.
Installing a Remote Insight cable (16-pin)
To install the Remote Insight cable (16-pin) (P/N 177634-001):
1. Power down the server and disconnect all power cords to remove power from the server.
2. Connect the 16-pin connector on the Remote Insight internal cable to the Remote Insight connector
(16-pin), located on the edge of the board.
3. Connect the 16-pin connector on the other end of the Remote Insight internal cable to the 16-pin
Remote Insight connector on the server system board.
NOTE: For detailed instructions on the location of the connector on the server system board, refer to the
documentation provided with the server.
4. Refer to the server documentation to reassemble the server.
Installing a Remote Insight cable (30-pin)
To install the Remote Insight cable (30-pin) (P/N 241793-010):
1. Power down the server and disconnect all power cords to remove power from the server.
2. Connect the 30-pin connector on the Remote Insight cable to the Remote Insight connector (30-pin),
located on the edge of the board.
3. Connect the 30-pin connector on the other end of the Remote Insight cable to the 30-pin Remote
Insight connector on the server system board.
NOTE: For detailed instructions on the location of the connector on the server system board, refer to the
documentation provided with the server.
4. Refer to the server documentation to reassemble the server.
Connecting external cables to RILOE II
After installing RILOE II in your server, connect the external cables. During normal operation, the RILOE II
passes the keyboard and mouse signals to the server and functions as the primary video controller. This
configuration allows the following operations to occur:
• Transparent substitution of a remote keyboard and mouse for the server keyboard and mouse