HP Remote Insight Lights-Out Edition II Board - Manual (Page 28)

Using the RILOE II 28
When you click Apply, RILOE II restarts. During the restart process, the connection from the browser
to the board is terminated. To reestablish a connection, wait 60 seconds before launching another
browser session and logging in to RILOE II.
Parameter Default value Definition
Transceiver Speed
Autoselect Yes Autoselect detects the interface speed and sets the interface to
operate at 10 Mb/s or 100 Mb/s and at half or full duplex. If
necessary, you can set this parameter to No so you can manually
adjust the speed and duplex settings.
Speed Autoselect Use this parameter to assign 10-Mb/s or 100-Mb/s connection
speeds if Transceiver Speed Autoselect is not enabled.
Duplex Autoselect Use this parameter to assign half or full duplex to the NIC if
Transceiver Speed Autoselect is not enabled.
Enable DHCP Yes This parameter enables you to select a static IP disables (No) or
enables the use of a DHCP server (Yes) to obtain an IP address for
the RILOE II subsystem.
You cannot set the RILOE II IP address and subnet mask if DHCP is
enabled.
Enabling DHCP allows you to configure the following DHCP options:
• Use DHCP Supplied Gateway
• Use DHCP Supplied DNS Servers
• Use DHCP Supplied WINS Servers
• Use DHCP Supplied Static Routes
• Use DHCP Supplied Domain Name
Use DHCP
Supplied gateway Yes This parameter controls whether RILOE II uses the DHCP server-
supplied gateway. If not, enter one in the Gateway IP Address box.
Use DHCP
Supplied DNS
servers Yes This parameter controls whether RILOE II uses the DHCP server-
supplied DNS server list. If not, enter one in the
Primary/Secondary/Tertiary DNS Server boxes.
Use DHCP
Supplied WINS
servers Yes This parameter controls whether RILOE II will use the DHCP server-
supplied WINS server list. If not, enter one in the
Primary/Secondary WINS Server boxes.
Use DHCP
Supplied Static
Routes Yes Toggles whether RILOE II will use the DHCP server-supplied static
route. If not, enter one in the Static Route #1, #2, #3 boxes.
Register with
WINS Server Yes RILOE II automatically registers with a WINS server. By default,
WINS server addresses are assigned by DHCP.
IP Address N/A Use this parameter to assign a static IP address to RILOE II on your
network. By default, the IP address is assigned by DHCP.
Subnet Mask N/A Use this parameter to assign the subnet mask for the default
gateway. By default, the subnet mask is assigned by DHCP.
Gateway IP
Address N/A Use this parameter to assign the IP address of the network router that
connects RILOE II subnet to another subnet where the management
console resides. By default, the gateway is assigned by DHCP.
RILOE II Board
Name N/A Use this parameter to assign a unique name to RILOE II. This name
can be used, if DHCP and DNS are configured as the address to
connect to RILOE II instead of the IP address.
Domain Name N/A Enter the name of the domain in which RILOE II will participate. By
default, the domain name is assigned by DHCP.
DHCP server N/A This parameter is automatically detected if Enable DHCP is set to
Yes. You cannot change this parameter.