HP StorageWorks ESL9000 Tape Library - Manual (Page 119)

Sense Data Values
119 HP StorageWorks ESL9000 Series Tape Library User Guide
02 04 00
LU IS NOT READY, CAUSE NOT REPORTABLE
Check library power. Retry command.
02 04 01
LOGICAL UNIT IN PROCESS OF BECOMING READY
Wait for library to complete initialization.
02 04 02
LOGICAL UNIT INIT REQUIRED
Element status or calibration unknown. Run an inventory command.
02 04 03
LU IS NOT READY, MANUAL INTERVENTION REQ’D
Initialization failed. Determine failure type by checking any previous error
code in the error log. Correct the cause of the failure and toggle Standby
button.
02 5A 01
OPERATOR MEDIUM REMOVAL REQUEST
Indicates that the element contains a cleaning cartridge that is used-up
and the library is unable to export the cleaning cartridge. Manually
unload the tape, and replace it with a new cleaning cartridge.
The load port door is open, so import/export elements can not be
accessed. Close the load port door.
02 80 00
DOOR IS OPENED INVENTORY MAY HAVE BEEN CORRUPTED
Close door and retry command. If the library is on-line, it executes its
initialization procedure. If not done automatically, run an inventory
command.
02 80 07
SYSTEM IS STOPPED (BUTTON IS CURRENTLY PUSHED)
The Stop button on the control panel was pressed. Press the Stop button
again to reactivate the robotics.
02 80 09
LOGICAL UNIT IS TURNED OFF-LINE
The library is ready to communicate with the diagnostic PC. Press the
Standby button on the control panel to place the library on-line.
04 80 00
GRIPPER AXIS INTERNAL FAIL
Upgrade firmware to latest revision.
Call your authorized service provider.
04 80 0A
NVRAM CHECKSUM FAILURE
Nonvolatile RAM contents are corrupted. Run the
INITIALIZE
NON-VOLATILE CONFIG
command and then a
CALIBRATE ALL
command.
Call your authorized service provider.
Table 26: Sense Data Values (Hexadecimal) (Continued)
Sense
Key ASC ASCQ Message Name/Description