Alto-Shaam Platinum Series ASC-4G User Manual

Page 10

Advertising
background image

Gas Convection Oven - Electronic Control

Pg. 9.

I N S T A L L A T I O N

V E N T I L A T I O N

VENTILATION HOODS

Proper venting along with a sufficient quantity of

make-up air is essential for proper oven operation.

A mechanically driven, canopy exhaust hood is the

preferred method of ventilation and must conform

to local codes along with the current version of

NFPA-96 Vapor Removal from Cooking Equipment

(latest edition). The oven hood must extend 6"

(152mm) beyond all sides of the oven. The distance

from the floor to the bottom edge of the hood

should be between 6'6" (1981mm) and 7' (2134mm).

A ventilation hood that supplies make-up air down

the back vertical wall should be avoided since air

currents can interfere with the oven flue exits. If

such installation is unavoidable, an additional draft

hood, specifically designed to deflect downdrafts,

must be installed.

DIRECT VENTING

When necessary, direct venting can be used in

situations where space is limited or to help offset

the high cost of ventilation hoods.

Direct venting should be installed in compliance

with local codes by a certified professional.

In the absence of local codes, refer to National

Fuel Code NFPA 54, ANSI Z223.1 (latest revision).

D A N G E R

FAILURE TO VENT THIS APPLIANCE
PROPERLY MAY BE HAZARDOUS TO
THE HEALTH OF THE OPERATOR.
Equipment damage, operational
problems and unsatisfactory baking
performance may also be the
consequence of improper venting.
Any damage sustained by a failure to
properly vent this oven are not
covered under warranty.

Ventilating hoods and exhaust systems shall

be permitted to be used to vent appliances

installed in commercial applications.

Where automatically operated appliances are

vented through a ventilating hood or exhaust

system equipped with a damper or with a

power means of exhaust, provisions shall be

made to allow the flow of gas to the main

burners only when the damper is open to a

position to properly vent the appliance and

when the power means of exhaust is in

operation.

IN ACCORDANCE WITH

NFPA 54

COMMONWEALTH OF MASSACHUSETTS ONLY

.

D A N G E R

Installation, air adjustment and/or
service work must be in accordance
with all local codes and must be
performed by a certified service
technician qualified to work on
gas appliances.

Advertising