HP StorageWorks XP Remote Web Console Software - Manual (Page 69)

4. Click a command. When two or more RCUs are selected in step 2, only the RCU Operation
command can be selected.
There is no separate pane for the port change operation. Select the port type, and go to the
Volume list (go to step 6).
5. Click Set. The pane closes, and the MCU/RCU list changes to the RCU Settings Parameter
list. Only RCUs selected in step 2 are listed, and items in the list depend on the selected
command.
NOTE: After being set, options can be modified and canceled (see “Modifying parameters
and deleting settings” (page 81) ).
6. Click Apply on the XP Continuous Access main pane. Settings are applied to the disk array.
The following sections describe each command and operation in detail.
Viewing RCU Status (RCU Status)
Use the RCU Status command to display RCU status information.
1. In the RCU Operation pane, click MCU&RCU in the Switch Display box.
2. In the CU Number/Port tree, click a CU number that includes the RCU you want to display.
3. From the MCU/RCU list, select an RCU, and right-click.
4. Click RCU Status. The RCU Status pane appears (see Figure 32 (page 69) ).
If you select more than one RCU in step 2, only the RCU Operation command can be selected.
Select one RCU in step 2 to display status information.
Figure 32 RCU Status pane
•
Path list:
No.: Path number (serial number of the list). ◦
◦ Path Status: Path status. Normal is displayed when path status is normal.
•
RCU S/N: Serial number of RCU.
•
SSID: SSID of RCU.
•
RCU CU#: CU number of RCU. When you select CU Free, Any appears.
RCU operations 69