HP SAN - Manual (Page 14)

Specifying SAN details
The SAN Settings window displays SAN details. It enables you to add and modify a SAN group.
Figure 3 shows the SAN Settings window.
Figure 3 SAN Settings window
.
Adding SAN details
To add SAN details, complete the following steps:
1. Click SAN Settings from the navigation area. The SAN Settings window is displayed in the main
display area. The default SAN name, MySAN, is displayed in the SAN Name box, as shown in
Figure 3 .
If you want to rename the SAN, then enter the name of the SAN that you want to scan in the
SAN Name box.
2. Click Rename. The SAN name appears in the SAN explorer area.
NOTE:
Raw data file generated by SAN Visibility uses the SAN name. For example, if the SAN
Name is MYHP, the raw report file is generated as MYHP.hp at the <Install_Dir>\
reports
directory.
A Component Group Name is a logical name to represent the collection of connected switches in the
SAN.
Using SAN Visibility 14