HP StorageWorks XP Remote Web Console Software - Manual (Page 80)

80 XP Performance Control Export Tool
Unsupported option: option The specified option is not supported. Correct the
specified option.
Some file exists in path.
What do you do? clear(c)/update(u)/stop(p)
You selected “action”. Is it OK? (y/n)
Files exist in path.
• To clear the files, press the c key.
• To overwrite the files, press the u key.
• To stop the operation, press the p key.
When pressing a key, a message appears and asks
whether to perform the specified action.
• To perform the specified action, press the y key.
• To cancel the specified action, press the n key.
Specify the following subcommand before login
subcommand: retry
The retry subcommand is written in an incorrect
position in the command file.
Write the retry subcommand before the login
subcommand.
Start gathering group data
Target = xxx, Total = yyy
End gathering group data
The Export Tool starts collecting data specified by the
group
subcommand.
The number of targets is xxx and the total number is
yyy
(see Note below).
The Export Tool ends collecting data.
NOTE: For example, suppose the array contains 100
parity groups and the command file contains the
following command line:
group PG 1-1:1-2
The Export Tool displays the message "Target=2,
Total=100"
, which means the group subcommand
specifies two parity groups and the total number of
parity groups in the array is 100.
Syntax error: "line" A syntax error is detected in a command line in the
command file. Check the command line for the syntax
error, and correct the script.
Note that some operands must be enclosed by double
quotation marks ("). Check the command line to find
whether double quotation marks are missing.
Table 27 Messages to be issued by the Export Tool (continued)
Possible problems Probable causes and recommended action