HP Officejet v40 All-in-One Printer - Manual (Page 49)

Chapter 11—Technical information 47
HP OfficeJet V Series
1RWLFH WR XVHUV RI WKH &DQDGLDQ WHOHSKRQH QHWZRUN
The Industry Canada label identifies certified equipment. This certification means that the equipment meets
certain telecommunications network protective, operational and safety requirements as prescribed in the
appropriate Terminal Equipment Technical Requirements document(s). The Department does not guarantee the
equipment will operate to the user's satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the
local telecommunications company. The equipment must also be installed using an acceptable method of
connection. The customer should be aware that compliance with the above conditions may not prevent
degradation of service in some situations.
Repairs to certified equipment should be coordinated by a representative designated by the supplier. Any repairs
or alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications
company cause to request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of the power utility,
telephone lines and internal metallic water pipe system, if present, are connected together. This precaution may
be particularly important in rural areas.
&$87,21 Users should not attempt to make such connections themselves, but should contact the appropriate
electric inspection authority, or electrician, as appropriate.
1RWLFH The Ringer Equivalence Number (REN) assigned to each terminal device provides an indication of the
maximum number of terminals allowed to be connected to a telephone interface. The termination on an interface
may consist of any combination of devices subject only to the requirement that the sum of the Ringer Equivalence
Numbers of all the devices does not exceed 5.
The REN for this product is 0.3B, based on FCC Part 68 test results.
1RWLFH WR DOO XVHUV RI WKH (XURSHDQ (FRQRPLF $UHD (($
This product is designed to interwork with the analogue telephone networks in the following countries:
Network compatibility depends on customer selected settings, which must be reset to use the equipment on a
telephone network in a country other than where the product was purchased. Contact the vendor or Hewlett-
Packard Company if addition product support is necessary.
This equipment comes with a telephone connector specific to the country where it was purchased.
This equipment has been certified by the manufacturer in accordance with Directive 1999/5/EC (annex II) for Pan-
European single-terminal connection to the public switched telephone network (PSTN). However, due to
differences between the individual PSTNs provided in different countries, the approval does not, of itself, give an
unconditional assurance of successful operation on every PSTN network termination point.
In the event of problems, you should contact your equipment supplier in the first instance.
1RWLFH WR XVHUV RI WKH ,ULVK WHOHSKRQH QHWZRUN
This equipment is designed for DTMF tone dialing and loop disconnect dialing. In the unlikely event of problems
with loop disconnect dialing, it is recommended to use this equipment only with the DTMF tone dial setting.
German UK Netherlands
France Spain Italy
Belgium Luxembourg Switzerland
Austria Denmark Sweden
Norway Finland Ireland
Greece Portugal