HP LaserJet M2727 Multifunction Printer series - Manual (Page 81)

3. Place the original document face-down on the flatbed scanner with the upper-left corner of the
document at the corner indicated by the icon on the scanner.
4. Gently close the lid.
Use copy
One-touch copy
1. Load the document into the automatic document feeder (ADF) input tray or onto the flatbed
scanner.
2. Press Start Copy on the product control panel to start copying.
3. Repeat the process for each copy.
Multiple copies
You can choose to have the default number of copies be any number from 1 to 99.
Change the number of copies for the current job
1. On the product control panel, press # of Copies .
2. Use the alphanumeric buttons to type the number of copies (between 1 and 99) that you want to
make for your current job.
3. Press Start Copy to begin copying your job.
NOTE: The change in the setting remains active for about 2 minutes after the copy job has been
completed. During this time, Custom settings appears on the product control-panel display.
Change the default number of copies
1. On the product control panel, press Setup .
2. Use the arrow buttons to select Copy setup, and then press OK .
3. Use the arrow buttons to select Def. # of copies, and then press OK .
4. Use the alphanumeric buttons to type the number of copies (between 1 and 99) that you want as
the default.
5. Press OK to save your selection.
NOTE: The factory-set default for the number of copies is 1.
ENWW Use copy 69