HP 3PAR Operating System Software - Manual (Page 244)

The upper pane of the RCFC tab displays summary information about the system's RCFC ports. The
lower pane displays details about a selected RCFC port from the upper pane.
The following information is displayed in the upper pane:
Description Column
The port location in node:slot:port format. Position
The state of the port. See “System and Component Status Icons” (page 41) . State
Indicates whether the port is FC, iSCSI, RCIP, or RCFC. Type
Port firmware mode setting. Ports in Initiator mode are connected to drive cages and
ports in Target mode export to hosts. Suspended mode is for target ports that have not
yet been initialized by the system (rare). Peer mode is for Ethernet ports. Mode
Type of connection (Private Loop, Public Loop, or Point-Point). Topology
Rate that data can be transferred over the port (1 Gbps, 2 Gbps or 4 Gbps). When
there is no specified value, no connection exists. Rate
World Wide Name of the remote port. Remote Port WWN
World Wide Name of the remote node. Remote Node WWN
The following information is displayed in the lower pane:
Description Field Group
Port location. Location General
Port World Wide Name. Port WWN
Node World Wide Name. Node WWN
Indicates whether the port is FC, iSCSI, RCIP, or RCFC. Type
Rate that data can be transferred over the port (1 Gbps, 2 Gbps or
4 Gbps). When there is no specified value, no connection exists. Rate
244 Viewing Remote Copy Information