GE GTWS8655DMC - Manual (Page 3)

3
GEAppliances.com
* Tide ® is a registered trademark of Procter & Gamble
SAVE THESE INSTRUCTIONS
WHEN NOT IN USE
„ Turn off water faucets to minimize leakage if a break or
rupture should occur. Check the condition of the fill hoses;
GE recommends changing the hoses every 5 years.
„ Ensure that the hot water hose is connected to the “H”
(internal red screened) valve and the cold water hose is
connected to the “C” (internal blue screened) valve.
„ Install or store where it will not be exposed to
temperatures below freezing or exposed to the weather,
which could cause permanent damage and invalidate the
warranty.
„ Properly ground washer to conform with all
governing codes and ordinances. Follow details
in Installation Instructions.
„ Optional drain hose extension recommended for
discharging heights from 60” - 96”.
„ This washer does not include water supply hoses.
GE strongly recommends the use of factory specified
parts. A list of factory hoses available for purchase are
listed. These hoses are manufactured and tested to meet
GE specifications.
GE strongly recommends the use of new water supply
hoses. Hoses degrade over time and need to be replaced
every 5 years to reduce the risk of hose failures and water
damage.
Parts and Accessories
Order on-line at GEApplianceparts.com today, 24 hours a
day or by phone at 800.626.2002 during normal business
hours.
Part Number
Accessory
PM14X10002 4 ft Rubber Water Supply Hoses
Or
PM14X10005
4 ft Braided Water Supply Hoses
WH49X301 Drain Hose Extension
WX10X10011 Tide ® Washing Machine Cleaner*
WX7X1 Washer Floor Tray
DR07X10005 6’ Cable
PROPER INSTALLATION
This washer must be properly installed and located in accordance with the Installation Instructions before it is used.
If you did not receive an Installation Instructions, you can receive one by visiting GEAppliances.com or by calling
800.GE.CARES (800.432.2737).
„ If the lid is opened between cycles (i.e. not pausing and
restarting the current cycle, changing cycles after it
started, etc.) pushing the Start button will cause the
washer to turn on the cold water for 5 seconds followed
by a 10 second delay before locking the lid and starting
the cycle.
„ If the lid is opened during this 15 second period, the word
PAUSE will start scrolling across its display. You will have
to push the Start button again to restart the cycle.
FUNCTIONALITY CHECK
¥
- Electrical Shock Hazard WARNING
Plug into a grounded 3 prong outlet.
DO NOT remove ground prong.
DO NOT use an adapter.
DO NOT use an extension cord.
Failure to do so can result in death, fire or electrical
shock.