Installation instructions, Warning, Water supply requirements – GE GTDX185EDCC User Manual

Page 8: Connecting inlet hoses, Connecting inlet hoses (cont.), Servicing

Advertising
background image

Installation Instructions

8

WATER SUPPLY REQUIREMENTS

Hot and cold water faucets MUST be installed within 42 in.
(107 cm) of your washer’s water inlet. The faucets MUST
EH  LQ  FP  JDUGHQ KRVHW\SH VR LQOHW KRVHV FDQ

be connected. Water pressure MUST be between 10 and
120 pounds per square inch. Your water department can
advise you of your water pressure.
NOTE: A water softener is recommended to reduce buildup
of scale inside the steam generator if the home water
supply is very hard.

12

CONNECTING INLET HOSES

(on some

models)

To produce steam, the dryer must connect to the cold
water supply. Since the washer must also connect to the
cold water, a “Y” connector is inserted to allow both inlet
hoses to make that connection at the same time.
NOTE: Use the new inlet hoses provided; never use old
hoses.
1. 7XUQWKHFROGZDWHUIDXFHWRȺ5HPRYHWKHZDVKHULQOHW

KRVHIURPWKHZDVKHU¿OOYDOYHFRQQHFWRU FROG 

2. (QVXUHWKHUXEEHUÀDWZDVKHULVLQSODFHDQGVFUHZWKH

IHPDOHFRXSOLQJ RIWKHVKRUWKRVHRQWR WKHZDVKHU¿OO
YDOYHFRQQHFWRU7LJKWHQE\KDQGXQWLO¿UPO\VHDWHG

3. Attach the female end of the ‘’Y’’ connector to the male

FRXSOLQJRIWKHVKRUWKRVH(QVXUHWKHUXEEHUÀDWZDVKHU
LVLQSODFH7LJKWHQE\KDQGXQWLO¿UPO\VHDWHG

4. ,QVHUWWKH¿OWHUVFUHHQLQWKHFRXSOLQJRIWKHZDVKHU·V

LQOHW KRVH ,I D UXEEHU ÀDW ZDVKHU LV DOUHDG\ LQ SODFH
UHPRYHLWEHIRUHLQVWDOOLQJWKH¿OWHUVFUHHQ$WWDFKWKLV

coupling to one male end of the ‘’Y’’ connector. Tighten
E\KDQGXQWLO¿UPO\VHDWHG

5. (QVXUHWKHUXEEHUÀDWZDVKHULVLQSODFHDQGDWWDFKWKH

dryer’s long inlet hose to the other male end of the ‘’Y’’
FRQQHFWRU7LJKWHQE\KDQGXQWLO¿UPO\VHDWHG

6. (QVXUH WKH UXEEHU ÀDW ZDVKHU LV LQ SODFH DQG DWWDFK

WKH RWKHU HQG RI WKH GU\HU·V ORQJ LQOHW KRVH WR WKH ¿OO

valve connector at the bottom of the dryer back panel.
7LJKWHQE\KDQGXQWLO¿UPO\VHDWHG

12

CONNECTING INLET HOSES (cont.)

7. Using pliers, tighten all the couplings with an additional

two–thirds turn.

NOTE: Do not overtighten. Damage to the couplings may
result.
8. Turn the water faucet on.

9. Check for leaks around the ‘’Y’’ connector, faucet and

hose couplings.

13

SERVICING

WARNING -

LABEL ALL WIRES

PRIOR TO DISCONNECTING WHEN

SERVICING CONTROLS. WIRING

ERRORS CAN CAUSE IMPROPER AND

DANGEROUS OPERATION AFTER

SERVICING/INSTALLATION.

For servicing phone numbers for replacement parts, and
other information, refer to Owner’s Manual or visit our
Web site.

5(*,67(5<2851(:$33/,$1&(725(&(,9($1<

,03257$17352'8&7127,),&$7,216

Please go to www.GEAppliances.com or mail in your

3URGXFW5HJLVWUDWLRQ&DUG

For questions on installation, call: 800.626.2000 (US) or

 &DQDGD 

Advertising