GE GTDL210GDWW - Manual (Page 7)

13 DRYER EXHAUST TO LEFT OR
BOTTOM
WARNING -
BEFORE PERFORMING
THIS EXHAUST INSTALLATION, BE SURE
TO DISCONNECT THE DRYER FROM ITS
(/(&75,&$/ 6833/< 3527(&7 <285
HANDS AND ARMS FROM SHARP EDGES
:+(1:25.,1*,16,'(7+(&$%,1(7
%(685(72:($5*/29(6
REMOVE
SCREW
AND SAVE.
REMOVE DESIRED
KNOCKOUT
(ONE ONLY).
Through the rear opening, locate the tab in the middle of
the appliance base. Lift the tab to about 45º using a flat
blade screwdriver.
BEND TAB
UP 45
o
LEFT SIDE
EXHAUST
PORTION "A"
FIXING
HOLE
MOBILE OR MANUFACTURED HOME
INSTALLATION
• Installation must conform to the MANUFACTURED
+20(&216758&7,21 6$)(7<67$1'$5'7,7/(
3$57  RU ZKHQ VXFK VWDQGDUG LV QRW DSSOLFDEOH
ZLWK $0(5,&$1 1$7,21$/ 67$1'$5' )25 02%,/(
+20($16,1)3$12%
• The dryer MUST be vented to the outdoors with the
termination securely fastened to the mobile home
VWUXFWXUH 6HH(;+$867,1)250$7,21VHFWLRQ 
• The vent MUST NOT be terminated beneath a mobile or
manufactured home.
‡7KHYHQWGXFWPDWHULDO0867%(0(7$/
‡.,7 ' 0867 EH XVHG WR DWWDFK WKH GU\HU
securely to the structure.
• The vent MUST NOT be connected to any other duct,
vent, or chimney.
• Do not use sheet metal screws or other fastening devices
which extend into the interior of the exhaust vent.
• Provide an opening with a free area of at least 25 sq. in.
for introduction of outside air into the dryer room.
• Stacking of a gas dryer is not permitted in a mobile
home or manufactured home.
11 TAB LOCATION
ADDING NEW DUCT
Detach and remove the bottom or left side knockout as
desired. Remove the screw inside the dryer exhaust duct
and save. Pull the duct out of the dryer. Protect sharp edges
around the knockout and exhaust opening with the tape.
Cut the duct as shown and keep portion A.
9"
A B
FIXING HOLE
5HFRQQHFW WKH FXW SRUWLRQ $  RI WKH GXFW WR WKH EORZHU
KRXVLQJ0DNHVXUHWKDWWKH¿[LQJKROHLVDOLJQHGZLWKWKH
tab in the base. Use the screw saved previously to secure
the duct in place through the tab on the appliance base.
GARAGE INSTALLATION (IF ALLOWED
%</2&$/&2'(6
‡'U\HUVLQVWDOOHGLQJDUDJHVPXVWEHHOHYDWHGLQFKHV
FP DERYHWKHÀRRU
12
ADDING ELBOW AND DUCT FOR
EXHAUST TO LEFT SIDE OF CABINET
• Preassemble 4” elbow with 4” duct. Wrap duct tape
around joint.
•,QVHUWGXFWDVVHPEO\HOERZ¿UVWWKURXJKWKHVLGH
opening and connect the elbow to the dryer internal
duct.
CAUTION:
Be sure not to pull or damage the
HOHFWULFDOZLUHVLQVLGHWKHGU\HUZKHQLQVHUWLQJWKHGXFW
DUCT
TAPE
Installation Instructions

• Apply duct tape as shown on the joint between the
dryer internal duct and the elbow.
DUCT
TAPE
CAUTION:
Internal duct joints must be
secured with tape, otherwise
they may separate and cause a
VDIHW\KD]DUG