GE ZV900SLSS User Manual
Page 14
INSTALL DUCT COVERS
• Place the decorative duct
covers on top of the hood.
NOTE: The inside (upper)
duct piece has holes on one
end. The holes are intended
for use when the hood is
installed for recirculating
purposes. Slide the inside end
into the outer piece; the vent
holes should not be visible in
this installation.
The inside duct piece must slip into the folded ends
of the outer section.
• Extend the inner duct upward to the ceiling
bracket.
• Secure duct cover to ceiling bracket with 2 screws.
Installation Instructions
,167$//$7,21³9(17('727+(2876,'(
14
Mounting
screws
INSTALL FILTERS
IMPORTANT: Check to be sure that the main ON/
OFF switch next to the motor is in the ON position.
• Remove protective film on the filters.
• Tip the filter into the left or right side of the
opening. Lift the filter to the opposite side and
into the filter lock.
• To remove the filter, pull the filter lock downward.
FINALIZE INSTALLATION
• Check to be sure all tape and packaging materials
have been removed.
• Refer to the Owner’s Manual for operating
instructions.
NOTE: The charcoal filter is not required for this
installation.
Duct cover
support bracket
Upper
duct cover
Lower duct
cover seat
Filter Lock
Duct cover
support bracket
Lower
duct cover