GE ZIRP360NXLH - Manual (Page 16)

Installation Instructions
16
STEP 6 SECURE UNIT TO WALL
‡7KH´/µURGVFDQEHIRXQGLQWKHXSSHUOHIWDQGULJKW
corners of the unit in the access compartment.
Look through the access compartment to make
sure the rods line up with the anti-tip bracket.
‡7KHUHDUHZDVKHUVDQGDKDLUSLQFRWWHUSHUURG
Remove the washers and hair pin cotter from the end
of the rod.
‡5RWDWHDQGPRYHWKH´/µURGLQWRWKHVORWLQWKHDQWLWLS
bracket tab. Once it is in the slot, rotate the “L” rod
VRWKHKRRNSRUWLRQLVSRLQWLQJGRZQ7KHKROHV
at the front end of the rod should be in a vertical
position. Do this to both sides.
‡3XOORXWRQWKHHQGRIWKHURGWRPDNHVXUHLWLVVHFXUH
in the bracket.
‡/RFDWHWKHKROHRQWKHURGWKDWLVFORVHVWWRWKHXQLW
A hair pin cotter will be put through this hole to secure
the rod. If this hole appears to be too far away for
a snug fit against the unit, add the washers one
at a time until the pin will fit tightly into the hole.
‡$OLJQWKHVWUDLJKWVHFWLRQRIWKHSLQZLWKWKHKROHIURP
the underside of the rod. Push the pin up until it snaps
into position. Pliers may be used. NOTE:7KHKDLUSLQ
cotter must be vertical when this step is completed
to ensure the “L” rod is engaged in the bracket.
‡&KHFNWKHURGIRUWLJKWQHVVE\SXOOLQJIRUZDUG
If the rod moves, remove the hair pin cotter and
place another washer on the rod. Reinsert the pin.
‡5HSODFHWKHJULOOHSDQHO