Brewer Basic 4000/4001 - Manual (Page 5)

Document #100087 RevC 5 Printed in USA © 2010
1. Carefully remove outer carton by removing the sta-
ples along the bottom of the carton and lift off table.
NOTE: Save all packaging in case re-shipment is re-
quired.
2. Unbolt the table from the shipping pallet by removing
the 4 bolt screws from the pallet with a 1/2” socket
wrench and remove the shipping bracket. See Figure
3.
WARNING
The table weighs approximately 190 lbs. Two or
more people should assist in removing the table
from the shipping pallet. Also, use proper lifting
techniques when lifting. Failure to do so could
result in serious injury.
3. Remove the table from the shipping pallet lifting at the
correct lift points indicated in Figure 3. The leg exten-
sions may be used for lifting.
CAUTION
Do Not use stirrup or stirrup beams for lifting table.
4. Position the table in the desired room location.
5. Remove plastic surrounding table. DO NOT use a
knife or any sharp object that could damage the up-
holstery.
Overview
Perform the following sequence in order when setting up
the table:
- Unpacking
- Leveling the Table
- Installing the Paper Rod
Unpacking
RECOMMENDED TOOLS:
- 1/2” socket wrench
- Pliers
NOTE: Inspect all boxes and contents for damage. Re-
port any damage to the carrier immediately.
CAUTION
To avoid damaging the table’s upholstery or paint-
ed surfaces, DO NOT use a knife or any other sharp
object to open the packaging.
INSTALLATION
Figure 3. Table Lift Points
CAUTION
To avoid damaging the table lift only at points indi-
cated in Figure 3.
Lift Points
Lift Point
Bolt Screw Shipping Bracket