AirSep MN138-1 H - Manual (Page 37)

31
MN138-1 Rev H
02/14
5.4
Tool Kit and Pressure Test Gauge
The tools needed for you to properly service the VisionAire unit are listed below:
Multi-adjustable pliers, small wire cutters, small needle-nose pliers, slotted-head screwdriver, Phillips-
head screwdriver, adjustable wrench, 1/2-inch combination wrench, 7/16-inch combination wrench,
9/16-inch combination wrench, and 1/8-inch Allen wrench.
Pressure test adapter. (AirSep p/n: KI257-2).
A pressure test gauge (AirSep p/n: KI036-1) to read operating system pressures on the VisionAire unit
should be kept available at all times.
An ohmmeter/multi-meter is a useful diagnostic tool when troubleshooting electrical components (coil,
etc).