Boonton PIM 21 User Manual User Manual
Page 4
4 | PIM 21 User’s Manual
Introduction
+70°C) or charged with excessive voltage. Prior to disposal,
the battery must be removed.
To reduce the hazard from overcharging never exceed the
maximum ‘Ext DC’ voltage of 16 Volts.
As an additional precaution, always remove BATT Fuse, prior
to storage for longer than 4 months.
Transportation Hazard
The device operates by using a transmitted RF Test signal,
which may interfere with navigation and other electronic
systems.
To eliminate the potential of this hazard always remove the
BATT Fuse, prior to transportation by aircraft or near any elec-
tronic security systems.
Disclaimer
PIM 21 transmits two CW RF signals with a power of up to 2 W
each to measure passive intermodulation of components and
transmitting systems. PIM 21 test systems are strictly built fol-
lowing customer’s instructions on these measurement frequen-
cies. Wireless Telecom Group and its subsidiaries are under no
circumstances accountable for use of PIM 21 not conforming to
laws and regulations of national and local authorities. Customer
/ user bear the full responsibility and legal accountability to use
PIM 21 only in a lawful manner.