Clinton Electronics CE-PTZ10x - Manual (Page 12)

12
DISPLAY SETUP
- - - - - - - - - - - - - - - - - -
DOME LABEL OFF
PRESET LABEL OFF
ZOOM LABEL OFF
ZONE LABEL OFF
DIRECTION LABEL OFF
TEMPERATURE LABEL OFF
TIME LABEL OFF
DATE LABEL OFF
BACK
EXIT
MOTION
- - - - - - - - - - - - - - - - - -
AUTO FLIP OFF
PROPORTION PAN OFF
PARK TIME 000
PARK ACTION NONE
POWER UP ACTION NONE
FAN ENABLED 113
BACK
EXIT
INITIAL INFO
Shows the serial number, current firmware version and other settings.
[BACK]: Move to previous screen
[EXIT]: Exit the OSD
DISPLAY SETUP
Customize the labels shown on the OSD
[DOME LABEL]: Shows dome label name on OSD
[PRESET LABEL]: Shows the current preset label on OSD (see pg.15; “Preset”)
[ZOOM LABEL]: Shows magnification setting on OSD
[ZONE LABEL]: Shows current zone (must first be set up: see pg.17; “Zones”)
[DIRECTION LABEL]: Shows current direction on OSD: Displayed as (Pan: 0º-359º,
Tilt: 0º-90º)
[TEMPERATURE LABEL]: Shows current temperature inside dome on OSD
[TIME LABEL]: Shows current time on OSD. Displayed as Year/Month/Day.
[DATE LABEL]: Shows current date on OSD. Displayed as 24 hour clock.
[BACK]: Move to previous screen (doing so will save your changes to display setup)
[EXIT]: Exit the OSD (doing so will save your changes to display setup)
MOTION
The motion control includes the setting for Park Time action and other features.
[AUTO FLIP]: Disabling this function will limit the tilt range to 90 degrees only
[PROPORTIONAL PAN]: Pan speed adjusts accordingly to the zoom ratio. The more
the operator zooms in, the slower the pan speed. The Park Time speed will be
adjusted accordingly.
[PARK TIME]: Sets the idle time in minutes, until [PARK ACTION] is activated.
[PARK ACTION]: You can select an action that will be started after certain idle time,
such as preset, tour or pattern. Select NONE to disable the function.
[POWER UP ACTION]: Instructs the dome to start a predefined action when
system boots up and completes the self test. This could be helpful to restore the
observation after power loss.
[FAN ENABLED]: Sets the temperature limit for the internal cooling fan to start.
[BACK]: Move to previous screen (doing so will save your changes to motion)
[EXIT]: Exit the OSD (doing so will save your changes to motion)
INITIAL INFO
- - - - - - - - - - - - - - - - - -
S/N: XXXXXXXXXXXXXXX
CLINTON V2.42
PROTOCOL: CLINTON
DOME ADDRESS: 001
COMM 9600, N, 8, 1
BACK
EXIT
DOME LABEL TEMP
PRESET LABEL
ZONE LABEL DATE
DIRECTION ZOOM TIME