EOTech Mini Red Dot Sight (MRDS) - Manual (Page 21)

2-7
b. On a standard 25-meter zeroing target, mark the designated strike point. In this
example, measure 6cm down from the center of the target.
NOTE
The designated strike point should be moved right or left if the MRDS is mounted
off-centered from the horizontal axis of the weapon barrel. If the MRDS is
mounted to the right of the barrel centerline, the strike point should be moved left
an equal distance. If the MRDS is mounted to the left of the barrel centerline, the
strike point should be moved right an equal distance.
c. Draw a designated strike zone around the strike point that corresponds in size to
an acceptable degree of accuracy (see Figure 2-5).