EOTech Mini Red Dot Sight (MRDS) - Manual (Page 27)

3-1
CHAPTER 3
MAINTENANCE AND SERVICING
SECTION I
MAINTENANCE INSTRUCTIONS
3.1 MAINTENANCE PROCEDURES
The operator should inspect the MRDS before each use and after it has been in extreme
conditions, such as prolonged exposure to intense temperatures. The following procedures
will extend the life of the MRDS and help ensure safe operation.
3.1.1 MRDS Housing
. To clean the MRDS housing, rinse with water or mild soap and water
and then wipe dry with a soft cloth. Clean around buttons and adjusters with a cotton swab.
3.1.2 Optical Surfaces . Optical surfaces should be inspected for foreign material. Remove
any large particles or loose dirt using air or a lens brush. Fine cleaning should be performed
using lens tissue and lens cleaning solution or the flexible cleaning tip of the lens pen. Avoid
using excessive force as this may scratch the lens.
NOTE
To ensure proper functioning of the MRDS, particular attention must be paid to
the cleanliness of the Red Dot Aperture shown in Figure 3-1.