Hootoo HT-UD01 - Manual (Page 32)

© DisplayLink 2014 – Issue 1 Page 32
DisplayLink USB Graphics User Manual
Software Version 7.6
The parameters are held below this registry key.
5.7.1. Network Address
The network address can be set by adding a new String Value, with the Name NetworkAddress. The value should be in
the format XXXXXXXXXXXX, where X is a hex digit between 0 and F.
5.7.2. VLAN ID
The VLAN ID can be set by adding a new String Value, with the Name VlanID. The value should be between 0 and
4095. Setting 0 will disable VLAN tagging.
5.7.3. Wake on LAN
Wake on LAN is enabled by setting the PnPCapabilities to “0”. To disable Wake on LAN, set PnPCapabilities to “110”
(Hex).
To set the Wake on LAN method, add a String Value with the Name WakeOnLan and a value. A list of the possible
values are stored below here in the registry under Ndi/params/WakeOnLan/enum. Use the Name (0 to 3) of these
enums as the Value for WakeOnLan