Hootoo HT-IP006N - Manual (Page 10)

Security Solutions Partner
10
Gateway: Make sure it is in the same subnet with your PC’s IP address. Gateway is the LAN IP of your router.
DNS Server: IP address of IPS network provider. You can also set it’s the same as the Gateway.
NOTE: You can find the Subnet Mask, Gateway, DNS Server from your router, or check the local connection
status of your computer to get all the parameters. Normally two DNS servers are optional.
Http Port: LAN port assigned for the equipment, default is 80. You could set another port number like 81, 801,
8001 etc.
User: Default administrator username is: admin (all lower-case)
Password: Default password is blank, no password.
NOTE: If the prompt “subnet doesn’t match, double chick to change!” appears, please set the IP Address,
Subnet Mask, Gateway, DNS Server once again, or enable Obtain IP from DHCP server.
2.1.1.3 Upgrade Firmware
Enter the correct Username and Password to upgrade system Firmware and Web UI. If you upgrade the
camera, Please upgrade system firmware first and then upgrade Web UI.（Figure 2.3）
Figure 2.3
Please download the firmware package before upgrade.
Follow the upgrade document in the package carefully to upgrade. Please read over the readme.txt file before
you do upgrade.
CAUTION: Sometimes, your camera may be damaged if not upgrading properly.
If your camera works well with the current firmware, we recommend that you don’t update it.
NOTE: When upgrading, please keep the power on, and use a direct connection with your network cable.
2.1.1.4 Refresh Camera List
Refresh camera list manually.
2.1.1.5 Flush Arp Buffer
When your cable network and wireless network of the device are fixed IP addresses. There is a problem you
may encounter when searching for the camera IP but can’t open the camera web page. You may try to use
Flush Arp Buffer.
2.1.1.6 About IP Camera Tool