King of Fans Valparaiso - Manual (Page 10)

Finishing the Fan
Installation
STANDARD CEILING MOUNTING
WARNING
WHEN USING THE STANDARD
BALL/DOWNROD MOUNTING, THE TAB IN
THE RING AT THE BOTTOM OF THE
MOUNTING PLATE MUST REST IN THE
GROOVE OF THE HANGER BALL. FAILURE
TO PROPERLY SEAT THE TAB IN THE
GROOVE COULD CAUSE DAMAGE TO
WIRING.
1. Align the locking slots of the
ceiling canopy with the two screws in
the mounting plate. Push up to engage
the slots and turn clockwise to lock in
place. Immediately tighten the two
mounting screws firmly.
2.
Install the remaining two mounting
screws into the holes in the canopy and
tighten firmly.
3. Install the decorative canopy ring
by aligning the ring' s slots with the
screws in the canopy. Rotate the ring
counter-clockwise to lock in place.
4.
You may now proceed to attaching
the fan blades.
CLOSE-TO-CEILING MOUNTING
1 Carefully unhook the fan from the
mounting plate and align the locking
slots of the ceiling canopy with the two
8.
screws in the mounting plate. Push up to
engage the slots and turn clockwise to
lock in place. Immediately tighten the
two mounting screws firmly.
2. Install the remaining two mounting
screws into the holes in the canopy and
tighten firmly.
3. Install the decorative canopy ring by
aligning the ring's slots with the screws
in the canopy. Rotate the ring counter-
clockwise to lock in place.
4. You may now proceed to attaching the
fan blades.
WARNING
LOCKING SLOTS OF CEILING CANOPY ARE
PROVIDED ONLY AS AN AID TO MOUNTING
DO NOT LEAVE FAN ASSEMBLY
UNATTENDED UNTIL ALL FOUR CANOPY
SCREWS ARE ENGAGED AND FIRMLY
TIGHTENED.
Attaching the Fan
Blades
Note : The blade side which marked
with " This Side Up" must toward the
ceiling after it is installed.
1. Insert the blade through the slot cut-
off in the center flywheel , align the
three screw holes in the blade with the
screw holes in the flywheel and secure
with screws provided (Figure 14).
2. Repeat for the remaining blades.
All blades are grouped by weight.
Because plastic blades vary in density,
the fan may wobble even though the
blades are weight matched.
The following procedure should correct
most fan wobble. Check after each step.
1. Check that all blade and blade
bracket screws are secure.
2.
Most fan wobble problems are
caused when blade levels are unequal.
Check this level by selecting a point on
the ceiling above the tip of one of the
blades. Measure from a point on the
center of each blade to the point on the
ceiling. Measure this distance as shown
in Figure 15. Rotate the fan until the next
blade is positioned for measurement.
Repeat for each blade. Measurements