King of Fans Valparaiso - Manual (Page 13)

Operating Your Remote Control 11.
Setting the Code
This unit has 16 different code combinations.
To set the code, perform the following steps.
A. Setting the code on the transmitter:
a. Remove battery cover. Press firmly below arrow and
slide battery cover off.
b. Slide code switches to your choice of up or down
position (factory setting is all up).
B. Setting the code on the receiver:
a. Slide code switches to the same position as set on
your transmitter.
b. Replace battery cover on transmitter.
CAUTION: Ceiling angle shall not exceed 30 degrees.
Remote Control Model: UC7067RYK.
Installing Receiver
WARNING: To reduce the risk of fire or electric shock,
remember to disconnect power. Do not use solid state fans,
electrical wire must meet all local and national electrical code
requirement. Electrical source and fans must be 120 volt, 60Hz.
Maximum fan motor amps: 1.5, Maximum Tungsten 300 watts,
or, Maximum Ballast 300 VA.
A. Wire connection:
Fan Green Wire
Bare Supply Wire
Black Receiver Wire (AC IN L) Black Supply Wire
White Receiver Wire(AC IN N) White Supply Wire
White Receiver Wire(TO MOTOR N) White Fan Wire
Black Receiver Wire(TO MOTOR L) Black Fan Wire
Blue Receiver Wire(FOR LIGHT) Blue Light Wire
NOTE: If other fan or supply wires are different color, have
this unit installed by a licensed electrician.
B. Lay the black antenna wire on top of the receiver and slide
the receiver into the mounting plate.
Operating Transmitter
NOTE: This remote is equipped with 16 code combinations.
To prevent possible interference from or to other remote units
such as garage door openers, car alarm or security system,
simply change the combination code but be sure that the code
on both transmitter and receiver are matched.
Install a 9 volt battery (not included).
Operating the fan
Hi Key---High Speed
Med Key--Medium Speed
Low Key---Low Speed
Light Key---Light On/Off
Reverse Key ---Fan Reversing Function
Fan Off Key---Fan Off