King of Fans Valparaiso - Manual (Page 11)

deviation should be within 1/8". Run the
fan for 10 minutes.
3. Use the enclosed Blade Balancing
Kit if the blade wobble is still noticeable.
Installing the Light Kit
/ Glass Bowl
CAUTION- To reduce the risk of
electrical shock, disconnect the electrical
supply circuit to the fan before installing
light kit.
1. Remove the three mounting screws
and lockwashers on the black bracket
below the fan motor (Figure 16).
2. Route the Blue wire and White wire
from the fan motor through the center
hole in the light kit plate.
3. Secure the light kit plate to the black
bracket using the three screws and
lockwashers that were removed in step 1.
4. Connect the Blue wire from the fan
motor to the Black wire from the ballast
by connecting the molded adaptor plug;
connect the White wire from the fan
motor to the White wire from the ballast
by connecting the molded adaptor plug
.
5. Remove the two screws on the light
kit plate.
6. Install the ballast to the light kit plate
using the two screws that were removed
in step 5 (Figure 17).
Touching
ceiling
Figure 15
7. With power off, carefully position the
circline lamp (Max. 30 watt, provided)
under the lamp retainer, make sure the 4-
pins on the circline lamp are located at
the bottom, near the connector from the
ballast. Snap both sides of the lamp
retainer over the circline lamp, carefully
engage the connector from the ballast
with 4-pins on the circline lamp (Figure
18).
9.