MBRP S7108 - Manual (Page 3)

S7108 © 12/12 PAGE 3 OF 4
Installation of MBRP Inc. Performance Exhaust:
Note; the SE lower valance has to be replaced with SRT/RT
lower valance. The SRT/RT lower valance can be purchased at
your local Dodge Dealer.
1. Slide two 2 ¼” Band Clamps over the remaining factory
exhaust pipes. Install the Extension Pipes using the 2 ¼” Band
Clamps leaving them loose enough for some adjustment.
Refer to Figure 5.
2. Slide two 2 ½” Band Clamps over the Extension Pipes and
install the Resonators onto the Extension Pipes.
Refer to Figure 6.
3. Slide a 2 ½” Band Clamp over the Resonator on the driver
side and slide the appropriate end of the Driver Side Tail Pipe
into the Resonator. Refer to the Illustration on Page 1. Slide the
hanger on the Driver Side Tail Pipe into the rubber insulator.
Refer to Figure 7.
4. Slide a 2 ½” Band Clamp over the passenger side Resonator
and slide the appropriate end of the Passenger Side Tail Pipe,
into the Resonator. Refer to the Illustration on Page 1. Slide the
hanger on the Passenger Side Tail Pipe into the rubber insulator.
Note it may be easier to remove the rubber isolator from the
vehicle and install it onto the Passenger Side Tail Pipe first.
Refer to Figure 8.
5. Attach the four M8 Exhaust Hangers to the frame where the
factory hangers were removed (two on each side).
Refer to Figure 9.
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9