Ridetech 11396799 - Manual (Page 2)

Installation Instructions
1. Raise truck and support under the frame at a safe, comfortable working height.
2. Support rear axle with jack stands.
3. Remove leaf springs.
4. Remove oem bumpstop and bracket
using a die grinder and a cutoff wheel. 5. This is how the frame should look
after oem bump stop removal.
6. Install lower airspring/shock
crossmember onto rear axle
housing using the supplied
u bolts as shown to the left.
7. Install the upper control arm
axle bracket onto the housing
cover using the supplied
fasteners as shown to the left.
Make sure to tighten all the
link bolts at ride height.