Ridetech 11396799 User Manual
Page 4
NOTE:
Due to the various locations of the emissions equipment, etc. over the years,
you may need to relocate items such as the charcoal canister, fuel lines, brake lines,
and electrical wiring. A little thought and care goes a long way here! Typically the fuel
lines, brake lines and wiring can be simply move aside if they are in the way, while the
charcoal canister may need to be repositioned entirely.
11. Install the lower bars into the axle
bracket and the OEM leafspring
mount. You will use the OEM
leafspring bolt for the front and the
supplied bolt for the axle bracket end.
12. Install the upper control arm into
the axle housing bracket and the gas
tank bracket. NOTE: The upper
control arm is NOT symmetrical. If it
is installed upside down, it will
position the rear axle approx 4” to the
right. If you incur this problem simply
flip the control arm over.