Ridetech 11366799 - Manual (Page 4)

13. Raise the lower bridge up to the
leaf spring pad. Place the upper axle
plate on top of the leaf spring pad and
secure with four 5/8” x 6” bolts, Nylok
nuts and flat washers. Tighten them
evenly.
Note: It may be necessary to tweak the
brake lines a bit to clear the bridge
assembly.
14. Install the 5/8” shock studs into the
lower bridge.
10. Bolt the upper cross member to
the frame using 7/16” x 1 ¼” bolts,
Nylok nuts and flat washers. It will
attach to the bottom side of the frame
rail & notch.
11. Attach the brake line to the tab on
the upper cross member. It may be
necessary to bend the brake line to
attach it to the cross member.
12. Thread the 5/8” upper shock stud
into the cross member.
15. Bolt the 4 link frame mount to the
frame utilizing the factory hanger bolt
holes. These holes must be drilled out
to 7/16”. Secure the assembly with six
7/16” x 1 ¼” bolts, Nylok nuts and flat
washers.
16. Attach the upper and lower bars to
the frame bracket using the 5/8” x 2 ¾”
bolts and Nylok jam nuts. The center-
to-center measurement on the bars
should be 26.5”.
Note: Be sure to tighten the bar bolts
with the axle at ride height.