Ridetech 11366799 - Manual (Page 5)

17. Attach the upper and lower bars to
the axle bracket assembly with 5/8” x 2
¾” bolts and Nylok jam nuts.
Note: After attaching the bars, make
sure the rod end jam nuts are tight.
18. Bolt the panhard bar axle bracket
to the diff. cover using three 5/16” x 2”
bolts, flat washers and lock washers.
19. The brake line will be relocated
using the “L” bracket supplied with the
kit. Secure the splitter to the “L” bracket
with the 5/16” x 1 ½” bolt, Nylok nut
and flat washers.
Note: The brake lines will need to be
rebent or new lines can be made.
20. Attach the panhard bar to the stud
using the large fender washer and
7/16” Nyloc nut. The center-to-center
measurement on the panhard bar is
17 ½”.
21. The other end of the panhard bar
will attach to the cross member with a
5/8” x 2 ¾” bolt and Nylok jam nut.
22. Install the 2” bump stop into the
notch. If you wish for the vehicle to
drop an extra 1 ½” a shorter bump stop
can be installed, but a hole must be cut
in the bed floor to allow clearance for
the differential.
Note: We offer a ½” tall bump stop,
Part # 90001082