Ridetech 11366799 User Manual
Page 6
23. Install the shock absorbers
between the upper cross member and
lower bridge using the supplied
hardware.
24. Apply thread sealant to the air
fitting and screw it into the top of the air
spring. Fasten the air spring to the
upper mount and lower bridge using
three 3/8” x 3/4" bolts, flat washers and
lock washers. Do not overtighten
these bolts, they just need to be
snug. Over tightening could pull the
inserts out of the air spring.
26. To allow clearance for the C-Notch
a section must be removed from the
bed floor brace. This section is
approximately 4” wide and about 7 ½”
from the fender well.
27. Check air spring, brake line &
parking brake cable clearance through
full suspension travel. Allowing the
air spring to rub on anything will
result in failure and in not a
warrantable situation.
28. Ride height on this air spring is
approximately 9” tall; should be around
60psi.