Ridetech 11370199 - Manual (Page 12)

25. The brace on the bottom side of
the bed will need to be removed for C
notch and axle clearance. This is best
done with a cutoff wheel. Double
check clearance with axle and notch
when fully deflated.
24. Install carrier bearing spacer
between carrier bearing housing and
cross member. Secure with 3/8” x 2
1/2” bolts.
26. Set the bed back on the frame and
reassemble. After tightening bolts
check axle, C-notch, and wheel
clearance. Note that the axle will shift
slightly from side to side through
suspension travel. Also check brake
lines, vent tube, and airlines for proper
slack.
27. Make sure nothing can touch
the air spring at any time through
full suspension travel.
28. This air spring should be
approximately 10.5” tall at ride height.