Ridetech 11370199 User Manual
Page 3
88-98 Chevy C-1500 Installation Instructions
*** Must Use RideTech Front Shock Kit ***
1. Apply thread sealant to the air fitting
and screw it into the air spring.
Assemble the upper cup bracket to the
air spring, using 3/8” Nylok nuts and flat
washers. Thread the 8” stud into nut
welded to the bottom of the cup. Bolt
the lower cup to the bottom of the air
spring using a 3/8” x 3/4" bolt, flat
washer and lock washer.
2. Place the assembly up into the
upper coil spring pocket; the stud will go
though the factory shock hole. Fasten
with a 7/16” Nylok nut and flat washer.
Note: The airline must also be routed at
this time.
3. Reattach the lower arm to the
spindle. The lower cup is not attached
to the lower arm; it will simply sit in the
coil spring pocket.