Ridetech 11250199 - Manual (Page 11)

16. Axle center is best determined by
dropping a plum on the outside of the
quarter panel and measuring into the
axle. This must be done with the car
level from side to side.
17. Once everything has been double-
checked you can tack weld the tabs the
axle. After removing the upper bar from
the tabs you can finish welding the tabs.
This will prevent you from frying the
bushings.
18. Reinstall the upper bar and snug all
bar bolt with the axle still at ride height.
The 4” spacer can now be removed.
19. A new 3/4" hole must be drilled for
the sending unit wire. You can reuse the
original grommet.
20. Apply thread sealant the air fitting
and screw it into the top of the
Shockwave.
21. The Shockwave will be secured into
place with 1/2" x 2 1/4" bolts and nylocs.
22. Check clearance with brake lines,
parking brake and vent tubes.
23. The exhaust can either be rerouted
under the axle or a turn down can be
installed.