Ridetech 11250199 - Manual (Page 8)

4. The upper bar mount will bolt to the
bottom of the car using the factory shock
bolts and locates off the factory shock
mount.
Note: The bar mount will point towards
the outside of the car. This is the
passenger side.
5. Using the bracket as a template drill 4
7/16” holes through the pan.
6. The upper bar bolt plate can be
dropped into place from the trunk. The
bracket will be clamped into place using
3/8” nylocs and flat washers.
7. Lower the axle enough to slide the
upper crossmember into place. The
frame is wider towards the rear of the car
as is the crossmember. Push it forward
until it is tight between the frame rails,
but make sure it is square. Drill two
holes with a 7/16” drill bit.