Ridetech 11250199 - Manual (Page 4)

4. Apply thread sealant to the air fitting
and screw it into the top of the
Shockwave.
5. Place the lower Delrin ball half over
the stud.
6. Hold the Shockwave up to the strut
tower with the stud protruding through
the upper plate.
7. Slide the upper Delrin ball half over
the stud, then the aluminum cap.
Secure the assembly w/ a 12mm Nylok
nut.
8. Raise the upper arm up to the
Shockwave and fasten the Shockwave
trunnion to the upper arm using two
3/8” x 1 ¼” bolts, nylocs and a washer
on each side.
9. Before reinstalling the strut tower
reinforcement plate route the airline.
10. Double check air spring clearance
through full suspension travel.
11. Driving pressure should be around
85psi, but will vary to driver preference
and vehicle weight.
1. Stud top base
2. Lower Delrin ball half
3. Upper Delrin ball half
4. Aluminum cap
5. 9/16” Nylok jam nut
6. Threaded stud
7. Adjustment knob (SA Only)
8. Screw
9. Snap ring (Coil Over Only)