Ridetech 41260000 User Manual
Page 2
TGR11000 Installation Instructions
• Initial fitment of the floor mount brackets must be done under the carpet. Final installation can
be done under or over the carpet.
• Use Anti-Seize on all fasteners that are threaded into stainless clamps or brackets.
• Install all bars before final tightening.
• Always tighten the tab side of the clamp first.
• Torque all 3/8” fasteners to 45 ft-lbs and all 1/2” fasteners to 75 ft-lbs.
• Make sure the clamp is exactly where you want it before tightening as the clamp may scratch
the tubing.
• Watch for fuel and brake lines when drilling holes through the floor pan.
1. The first bracket to be mounted
needs to be the main hoop floor
mount. It should be mounted 2 3/8”
behind the rocker panel seam.
2. The wire trough cover needs to be
notched to allow clearance for the
hoop mount. Mark the bracket
location on the wire trough cover.
Remove cover and cut the marked
section out.