Ridetech 41260000 - Manual (Page 5)

17. Using the trunk bar plate as a
template, drill six 3/8 holes through
the trunk floor. Drop six 3/8” x 1 ¼”
bolts with flat washers down through
the holes.
18. Place the reinforcement plates up
against the bottom of the trunk pan
(one on each side of the frame rail)
and secure with 3/8” Nylok nuts and
flat washers.
Note: The plate with 4 holes will be
installed to the outside of the rail.
14. Bolt the trunk bar up to the
package tray bar with 3/8” Nylok nuts
and flat washers.
15. Using the bracket as a template
drill two 3/8” holes through the vertical
surface of the package tray.
16. Place the reinforcement plate
inside the car and fasten with two 3/8”
x 1 ¼” bolts and Nylok nuts.