Ridetech 41260000 User Manual
Page 3
3. Using the bracket as a template
drill four 3/8” holes in the floor pan.
Fasten the upper holes in the bracket
to the quarter panel structure with two
3/8” x 1 ¼ bolts, flat washers and
Nylok nuts. A reinforcement plate
will be installed inside the quarter
panel.
7. In order to keep the “T” in the
casting facing up, and the bolts facing
the correct direction, there are two
different direction clamps. Be very
careful as to which clamp halves you
are bolting together. Refer to the
image on page 6 for clamp locations.
8. A correctly assembled clamp
should look like the one in the picture
shown to the left; there should be a
gap on one side for the tab to slide
into.
4. Secure the lower portion of the
bracket to the floor pan with two 3/8” x
1 ¼” bolts, flat washers and Nylok
nuts. Another reinforcement plate will
be installed under the car. It will also
meet up with the body seam.
5. Two more 3/8” holes must be
drilled through the body seam. 3/8” x
1 ¼” bolts, flat washers and Nylok
nuts will be used here.
6. Fasten the main hoop to the
mounts using 3/8” x 1” Socket Head
Cap Screws and lock washers.