Ridetech 41240000 - Manual (Page 3)

11. Using the template on page 6;
drill four 3/8” holes into the top of the
package tray.
12. Attach a “D” Clamp to the main
hoop with the tab facing rearward
with the top of the clamp
approximately 35 1/8” above the floor
mount . Use 3/8” x 1” socket head
cap screws on the clamp.
13. Place the driver side package
tray bar on the package tray and
secure it to the clamp with a ½” x 1
½” 12 point bolt and flange nut.
7. The hoop mount ties into the
outside of the frame rail with this
bracket. Two 3/8” Nylok nuts with flat
washers will fasten it to the floor and
four 3/8” x 1” self-tapping screws will
secure it to the frame rail. Use a
5/16”’ bit to pre-drill the holes.
8. Bolt the main hoop to the floor
mounts using four 3/8” x 1” socket
head cap screws.
9. In order to keep the “T” in the
casting facing up, and the bolts facing
the correct direction, there are two
different direction clamps. Be very
careful as to which clamp halves you
are bolting together. Refer to the
image on page 5 for clamp locations.
10. A correctly assembled clamp
should look like the one in the picture
shown to the left; there should be a
gap on one side for the tab to slide
into.