Ridetech 41240000 - Manual (Page 4)

16. Using the trunk bar as a
template drill two 3/8” holes through
the vertical surface of the package
tray.
17. Place the reinforcement plate on
the inside of the package tray and
secure with assembly with two 3/8” x
1 ¼” bolts, flat washers and Nylok
nuts. Nuts should face the trunk.
18. Using the trunk bar as a
template; mark the 4 hole in the floor
pan with a center punch. First drill
the hole with a 1/8” bit. Before
drilling the holes to 3/8”, hold the
frame bracket up against the frame
rail to ensure that the bolt holes will
align. Re-drill 1/8” holes if
necessary.
19. Drop four 3/8” x 1 ¼” bolts with
flat washers down through the floor
pan.
14. Drop four 3/8” x 1 ¼” bolts with
flat washers down through the bar
mount and the holes in the package
tray.
15. Fasten the trunk bar to the
package tray bar with four 3/8” Nylok
nuts and flat washers.