Rocky Mountain Radar RMR-C435 - Manual (Page 4)

CONTROLS: There are 3 buttons on top of the
RMR-C435: Dim, Mute and City.
Dim: Press the Dim button for a split second
(momentary contact) to dim the alarm lights. There
are 3 levels of illumination. To brighten the alarm
lights press the dim button again. The unit will have
two beeps for “dim”, “dimmer” and “dark”, and one
beep for “bright”.
Mute: Press the Mute button for a split second
(momentary contact) to disable the alarm speaker for
quiet operation. To reactivate the alarm speaker
press the Mute button again. The unit will have two
beeps for “mute on” and one beep for “mute off”.
Auto-Mute: Press the Mute button for a split second
(momentary contact) to disable the alarm speaker for
quiet operation. In Auto-Mute operation it will beep
the signal 3 times then switch to mute automatically.
City: Engage the City function to reduce false
alarms in high RF noise areas. City function has 3
levels of sensitivity, City 1, City 2, and Highway
mode. Press the City button for a split second
(momentary contact). With City 1 mode “X” Band
will be turned off and K – Ka sensitivity will remain
100% active. City 2 mode “X” Band will remain off
and K – Ka sensitivity will reduce to 50%
sensitivity. Highway mode has all bands at 100%
sensitivity. The unit will have two beeps for “city
1”, three beeps for “city 2” and one beep for
“highway”.
Selectable Tone: The RMR-C435 has selectable
tones. To change the tone of the unit, press and hold
the Mute button down for an extended period of
time (approximately 3 to 5 seconds). A flat tone
buzz changes the tone. Three beeps returns the
setting to normal.
Selectable VG2 alarm: To activate VG-2
detection, press and hold the City button down for
an extended period of time (approximately 3 to 5
seconds) until unit beeps 3 times, VG2 is now on.
VG-2 detection is now activated. To deactivate
press and hold the City button for an extended
period of time (approximately 3 to 5 seconds) until
unit beeps a flat tone buzz. VG-2 is now off. The
unit will have three beeps for “VG2 on” and a flat
tone buzz for “VG2 off”.
3