SIGMA MC 1812 MOTO - Manual (Page 13)

Mode 2
Mode 1
Reset
Set
Mode 2
Mode 1
Reset
Set
Total distance
Basic settings
www.sigmasport.com MC 1812 Page 13
MC 1812
4.4 Total distance
Use this area to enter existing values (e.g. transferred from your old device). New
values are then added to these (see also section „5.2 Trip distance“).
1 Press the
Mode 1
button to switch to the ‘Total dist.’ display.
The total distance is displayed.
2 Press the
Set
button.
3 The first digit for entry flashes (displayed with thousands separator).
4 Press Mode 2 (+) or Reset (-) to set the value.
5 Press the
Mode 1
button to switch to the next digit.
6 Repeat the process.
7 Press the Set button to save your setting.
‘Set OK’ appears on the display.
4.5 Total time
Use this area to enter existing values (e.g. transferred from your old device). New
values are then added to these (see also section „5.3 Trip time“).
1 Press the
Mode 1
button to switch to the ‘Total time’ display.
2 Press the
Set
button. The first digit for entering the hours (h) flashes
(attention: a dot appears on the display as a thousands separator!).
3 Press the
Mode 2
(+) or
Reset
(-) button to set the value and the
Mode 1
button to
move to the next digit.
4 Repeat the process.
5 Once you have changed all four digits for the hours indicator, press the Set
button to move to the minutes input.
6 The first digit for entering the minutes (min) flashes.
7 Press the Mode 2 (+) or Reset (-) button to set the value and the Mode 1 button to
move to the next digit.
8 Press the
Set
button to save your setting.
‘Set OK’ appears on the display.