APW Wyott VSX User Manual

Page 16

Advertising
background image

10. PROCEDURE FOR CONVEYOR BELT TRACKING

FIGURE 12:

Silicone Belt Tracking Adjustment

Conveyor belt tracking is checked at the factory. New toasters

should not need adjusting. If, after replacing the silicone belt

as described under the periodic maintenance procedure, it

begins to "walk" toward one end of the conveyor or another,

use the Belt Tracking Screw to align the belt to the center of

the conveyor (See Figure 13 and page 19). Keeping the belt

centered, along with regular cleaning, helps preserve the life

of this belt. To adjust the screw, you will need a 3/16" Allen

(hex) wrench or a flat-head screwdriver, depending on your

toaster. Turn the screw in the direction the belt appears to be

"walking" to bring it back to the center of the conveyor. After

adjusting, check the tracking periodically for the first hour to

verify the belt is still centered. Overadjustment may cause the

belt to begin to "walk" in the opposite direction. If this occurs,

TOOLS NEEDED: Needle-nose pliers

A.

Turn off toaster. Let cool for 30 minutes.

B.

Remove top lid and open front cover

C.

Turn the Bun Thickness Dials straight up.

D.

Turn toaster on and depress top lid switch button until

the belt splice (flap) is at about the center of the

conveyor. Turn toaster off.

E.

Remove the pin from the splice using the needle-

nose pliers

re-adjust by turning the screw again in the opposite direction (again, turn in the direction the belt is walking).

Two to three rotations of the screw should be enough to center the belt on the conveyor. Also see the flow

diagram on the page 19 for belt tracking instructions.

A

C

D.1

D.2

E

F.

Remove the old belt from the toaster. (CAREFUL!!!

MAY BE HOT! YOU COULD BURN YOURSELF!)

G.

Put the new belt on. The “WWW” treads should face

out and touch the buns. Feed the belt through the

conveyor using the end of the belt without flaps.

(CAREFUL!!! MAY BE HOT! YOU COULD BURN

YOURSELF!)

H.

Put pin in splice. The right & left sides of the belt

should line up straight. Make sure that the belt is

routed

the plastic roller. Make sure belt is in

center of conveyor. Make sure that the flap (over the

splice) is facing you and hanging down.

I.

Close the front cover and turn to the rear conveyor.

J.

Repeat steps D-H for rear conveyor.

OVER

11. PROCEDURE FOR CHANGING A BELT

B

D.3

L.1

L.2

M

K

K.

Close the rear cover and replace the lid.

L.

Turn toaster on and turn knobs to their normal settings.

M.

Watch the conveyors to see if belts ride over the sprockets. If they do, follow procedure for belt

adjustment (see section 13, page 19).

BOTH SIDES

16

Advertising